Testing Apparatus

The CKE Vertical Rain Test apparatus is to verify Protection against Vertically Falling Water Drops. It is designed and manufactured in accordance with the standard requirement of IEC60529 clause IPX1 and IPX2.
The rise and fall of the drip box is controlled by the motor. It is equipped with the rotatable objective table whose rotating speed is 1r/min for IPX1 test. It is also equipped with 15°bevel for supporting sample for the IPX2 test. 

This test apparatus checks the protection of the supply cord where it enters the appliance. It conforms to the standard requirement of IEC60335-1 clause 25.14. Appliances provided with a supply cord that are moved while in operation shall be constructed so that the supply cord is adequately protected against excessive flexing where it enters the appliance. This does not apply for appliances with automatic cord reels.

The Lamp Cap Temperature Rise Tester applicable under normal operation and is detected lamps temperature air convection under abnormal operation ,to prevent the effects of air temperature and thermal radiation from the light source to the sample.

The UL 94 Flammability Test Apparatus is widely used for testing the electrical and electronic product like lighting equipment, low-voltage apparatus and electrotechnical instrument.

The glow wire test chamber is widely used for testing the electrical and electronic product like lighting equipment, low-voltage apparatus and electrotechnical instrument.

Laboratory Hot Set Test Apparatus is designed to determine the Elongation & permanent set of insulation of electric cables under specified conditions of load, temperature and airflow.

A double walled cabinet with inside chamber of stainless steel and outside of mild steel fully powder coated inner dimensions of the chamber are 450 mm x 450 mm x 450 cm (LxBxH). The door is fitted with a glass to observe the specimen under test.

Temperature Range of oven is Ambient to 300 ± 2C at sensor point. Controlled by Digital Temperature Indicating Controller.

The Needle Flam Test Apparatus is widely used for testing the electrical and electronic product like lighting equipment, low-voltage apparatus and electrotechnical instrument.

Oscillating tube tester is designed and manufactured in accordance with the standard requirement of IEC60529 IPX3 and IPX4. It is used for the waterproof test of the electrical equipment.
The oscillating tube part of this device is controlled by PLC motor mechanism. This device is reciprocating swing from the place of ±60°to another one of ±170°with the speed required by the standard through machine adjusting angle.
The angle adjustment is accurate. The structure is stable and durable. It is equipped with rotating stage through which the rotating of 90°can be achieved. 

The Pull out test apparatus application is check tha all material  strength like gland, MCB,RCCB, Plug etc….

The Secureness Test Apparatus application is Checking of connector, MCB,RCCB, Lug cable clamping.